Marker | Photoluminescent | 1" x 100' Tape Roll [PT1]
A simple way to add additional emergency egress signage. Meets stringent New York City safety codes (New York City Building Code Reference Standard RS 6-1 & 6-1A and Local Law 26 of 2004). Tape is highly visible, displaying a safe evacuation path in the event of emergency.
No electricity or battery required. Easily affixes to walls, handrails, columns, around door frames, and along stairways and baseboards. Non-slip, high-traction surface allows for placement on floors and stair steps. Under normal lighting conditions, highly visible. In the event of low (or absence of) lighting due to power failure the tape will "glow-in-the-dark" - must be "charged" to glow, requires exposure to 54 LUX (5-ft candles) of LED, fluorescent, metal halide or mercury vapor light illumination.
Existing tape must be removed first, using a heat gun to warm the existing material and then get an edge started or use scraper. Any residual adhesive can be removed with a commercial solvent adhesive remover.
This product is compliant with the Americans with Disabilities Act.
This unit uses long lasting, electricity free Photoluminescent Lighting (Glow in the Dark) Technology.
This unit is made in the United States.
- No electricity, no batteries
- Thin gauge polyester film
- Peel-off adhesive backing makes installation easy and low-cost
- Requires 54 LUX (5-ft candles) of LED, fluorescent, metal halide or mercury vapor light to charge material for 60 minutes
- Install indoors only
- Non-toxic and non-radioactive
- High tack tape sticks to rough surfaces
- Long life expectancy
- No future hazmat disposal needed
The PT1 egress tape is made from flexible, photoluminescent polyester film coated with a permanent acrylic adhesive. Engineered to exceed requirements for emergency egress and meet the industry's most rigorous standards.
The PT1 egress tape does not require any type of electrical components.